Air Winkelpolierer

Application 1:It's used for welding the groove and thinning the welding line. 2:It's used for cutting the metal sheet and the small steel. 3:It's used for thinning,rust-remove polishing. The Right Way of Operating the Air Tool and Maintenance 1. The pressure that go into the tool is 0.63Mpa normally. 2. Compressing air must contain lubricating oil, which is supplied by lubricator. 3. Compressing air shouldn’t contain water, and on the conduit must has a device to filter water. 4.Borkers mustn’t use the tool that was dismantled some accessories in case of danger and break it. 5.Maintaining tools regularly (about once a week), and pouring lubricating oil at the motor(under 10#), laying on grease to the axletree(Grense). 6.When tools have problems or the function can’t reach the standard, check and repair them right away. 7.Workers should choose suitable tools, because the high power tool will injure the workpiece, and the low power tool will injure the tool itself. 8.Works can’t strike the tool with a strong force, and they should assure the tools’ safety protection in case of danger.