ZF-1800B hair dryer,home appliance,beauty products

Using the dryer After washing towel your hair and then use the dryer. Plug in appliance and select the Switch position for the right temperature and airflow. Select the cool shot position. Using cool shot has a good protection on hair,which has been dried and made up. After using, please place the switch at “0”position and then disconnect the dryer.Important Connect the dryer to 220-240 volt outlet. Never use in the bathtub,shower, or over a filled sink. Do not use cleaning solutions or abrasives for cleaning the hair dryer. Never lay it down on a humid pillow or blanket when in use. Make sure that the air inlet and air exit grills are free when using the unit.The dryer is protected against overheating.If the air inlet is accidently covered,the dryer will stop automatically.Switch off and allow to cool down,for a few minutes before attempting to restart. Disconnect after use. Children are not aware of potential hazards.Do not allow children to operate this appliance.Make sure they are under supervision whenever they use the hair dryer.Cleanig your dryer Please always disconnect your dryer before cleaning.Do not immerse in water.Protect your dryer unit against dust or oil.From time to time remove dust and hair from the hair inlet grill with a small brush. You can clean your appliance with a slightly damp cloth and dryer it up with a dry cloth provided the hair dryer is disconnected from the mains supply first. WARNING Do not use this appliance near water in bathtubs,basins or other vessels. When the hair dryer is used in bathroom,unplug the appliance after use since the proximity of water presents a hazard,even when the hair dryer is switched off. For additional protection the installation of a residual current device (RCD)with a rated residual operating current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom. Ask yout installer for advice. Do not pull the cord with unnecessary force. Do not damage or modify the cord. If the supply cord is damaged,it must be replaced by the manufactuer its service agent or a similarly qualified person in order to avoid a hazard.