YT高温R丁V硅胶合剂

YT HI-TEMP RTV SILICONE INSTANT GASKET is based on repairing norm for China auto company to develop neutral silicone sealant.The gaskets are enable to resist high Pressure, cracking, shrinking and migrating caused by thermal cycling. Temperature range from -85°F to 580°F (-65°C to 300°C) intermittent, ideal for water pumps and thermostat housing. Valve covers, oil pans, exhaust manifolds, intake manifolds, timing covers, excellent heat control and torque retention. DIRECTIONS: 1. Clean and dry surfaces, erase completely all dirt & grease with a residue free solvent. 2. Take away the cap, puncture the inner seal, and screw on the nozzle cut at the desired bead sise. 3. Apply the beads evenly around the perimeter or one surface. 4. Normally material skin in 15 minutes, assemble parts once silicone skins over. 5. Sealant is fully cured in 24 hours. Use the knife to remove excess silicone. 6. Clean the nozzle and put back the cap tightly after use. If the sealant cures in the nozzle, remove the cured plug with a pin or paper clip. NOTE: 1. Flexible and stable at all temperatures from -85°F to 580°F (-65°C to 300°C). 2. Not recommended for continuous immersion in gasoline. 3. Do not use instant gasket only when replacing cylinder head gaskets with predetermined Tolerances. CAUTION: 1. On contact, uncured sealant causes irritation, avoid contact of eyes and skin. In case of contact, Flush eyes with water, remove from skin with a dry cloth and call physician immediately. 2. Use with adequate ventistion. 3. Use lid to tightly seal if it was not used up. Keep out of reach of children.