WZPM series of PT100 Sensor

WZPM Series ofPT100 SensorFor Windmill generatorSummary the product obeys IEC60751 standard and state explosion protection standard with good Linearity , high precision, long life. We have types of temperature-measuring terminal , it is used for explosion protection motor and generator etc , temperature measurement and control is by bearing, and match with Temperature control meter using, temperature-measuring terminal of sensor is installed in the devices ,lead out wire connect to matching meter ‘s signal input terminal . .it can display real-time temperature measuring and carry out action to equipment at temperature-control point which have been selected.Installation instruction sensor is installed in the parts which needed to temperature testing ,don’t give too much tension to sensor ,lead out wire is connected in increased safety –terminal box which the protection grade is not lower than IP45,shielding wire should connect to motor housing ,It should make sure that it fits the requirements of increased safety- explosion protection after installing Sketch map instruction as the sketch ,hitting a hole in the motor bearing room ,matching with matched screw thread then striping the bearing sensor with screw thread together ,and installing sensor strongly , the side of sensor contact with bearing outer ring ,,lead out wire is connected in the terminal box ,it will avoid dropping when it in the transport and motor works