UXP600 series Power resistors

UXP600 series Power resistors For variable speed drivers, power supplies, control devices, robotics, motor control and other power designs, the easy mounting fixture guarantees an autocalibrated pressure to the cooling plate of about 120 to 160 N. General Characteristics Electric support:High alumina ceramic metallized with EBG ALTOX film on the bottom for better heat transfer and optimum discharge. Encapsulation:Special resin filled epoxy casing with large creeping distance to mass, large air distance between the terminals and high insulation resistance (CTI 600). Resistance Element:Special design for low inductance and capacitance values. The element employs our special METOXFILM which demonstrates stability while covering high wattage and pulse loading. Contacts:Easy load connecting with M4 or M5 screws. Connector height (M+N) available from 25 to 42mm. Various sleeves for increased creeping distance up to 85mm or potted cable connections are available on special request Materials in accordance with UL94-V0 Resistance Values:0.5Ω to 1MΩ Resistance Tolerance:±5% to ±10% Temperature Coefficient:±150ppm/°C (others upon request) Maximum Working Voltage:5,000V DC, higher voltage on request, not exceeding max. power Short Time Overload:1,000W at 70°C for 10sec.,∠R = 0.4% max. Power Rating: 600W at 85°C Bottom case temperature. Peak Current: up to 1500 Amp.depending on pulse length and frequency Electric Strength Voltage:6kVrms, 50Hz,upto 12kVrms on special request. Single Shot Voltage: up to 12 kV Normwave (1.5/50 μsec) Partial Discharge:4KVrms,<10pC, up to 7kV on special request Insulation Resistance:10GΩ Min. at 500V Creeping Distance: 42 mm Min. Air Distance:14 mm Minimum Inductance: 80nH Capacity/Mass: 110pF Capacity/Parallel: 40pF Operation Temperature:-55°C to +150°C Max. Torque for Contacts: 2 Nm Max. Torque for Mounting:1.8 Nm M4 screws