Strech film

PVC cable The plastic injection molding, the die is good, and die very light, not accounting for the weight of the die on both sides brings a smooth and will not cut fingers, but also speed up the workers, the packaging speed, improve work efficiency! (1)the same thickness, width of the conditions, pull, Ren relatively better. Film will not harden in winter. Moisture,dust. (2)because film is a good first cut of re-winding up, and therefore do not appear due to the phenomenon of biting edges and broken membranes. The entire film can be used in the end, exhausted, loss of small! (3)this sub-cut film products are currently used the most advanced cutting out of the machine, the die diameter according to national standards designed to be an inch, it can be applied to the machine packaging. (4)Order Note:This product is cold in the winter add a production agent, increasing the viscosity; summer production is no need to add cold agent, to reduce viscosity. Please do not purchase when you use across the season to avoid winter into the summer, when used too much retention would be too sticky, but it difficult to pull, but in summer the winter of purchase when used too much retained its viscosity and it looks bad some, there is no viscous , resulting in thin-film brittle. Please note that the above works.