Standby Power Saver

Standby Power saver,Standby killer,Master-slavesocket Device: Features: Saving Energy A: Standby power saver for electronic products B: Low standby power consumption Saving Money: A: Electricty fee saving by shutting down standby power of electronic products B: Pay bak itself within the first few months of usage C: Prolong the electronic life cycle Environment Protection: A: Decrease CO2 emissions Saftey A: Protect electronic products form transient high voltage causing by thunder strikes or surge B: Reduce the fire risk by total cutting power to electronic products not in use Convenience: A: Ease of installation and use B:With a standby power saver socket and and AC power Extension socket, The extension socket is for electronic product that is not suitable for standby power saver. Technical features: 250V,50Hz,10A,2300W,IP20 Class I,non-rewirable, 4 Way power saver socket,1 master,3 slave sockets How to use: With its front facing you, hold it a direction that makes it look like an upside down T. on its back, the single pin should be adbove the horizontal pair pinsExamine the wall on which you will plug it A: If there is no skirting board under the wall socket, you can plug eigher it upward or downwards. B: If there is skirting board below the wall socket to cause the plug unable to reach and thus be inserted into the wall socket securely,change its direction. 1) Press the buttion under the dial 2) Grip the finger grip of the dial with your thumb, index finger and middle finger 3) Rotate the dial anti-clockwise 180 degrees till it snaps. (as in the picture to the left) 4) Now the signle pin is under the horizontal pair pins, Then, turn the whole plug usside down . it now looks like a T. Examine the wall socketA: If the wall socket is a flush one, just plug the product on to the wall socket B: If the wall socket is a raised one, insert the two back supports into the holes in the back of the plug.adjust the length (40to 45mm) of the supports till the length is equal to the distance prom the back of the plug to the wall.then lug it on the wall socket. To use this adaptor simply plug in a device into one of the 5 sockets and switch on the corresponding switch(for that socket) for the non switched socket just connected the plug to that socket and power will automatically flow to the connected device.If you buy the product with surge protector, the green surge protection light will light , it means all the sockets on it are surge protected. When the green light is off, it means the surge protection is not working. This means that any devices plugged into the T-socket adaptor will not be protected from surges or spikes in the supply