SlimHID压（最佳的质量)

HID BallastSpecification and Test Item SlimHID Ballast1.work temperature : -30.c +85.c Color: black or silver 2.Recoder is available3.HID running parameterInput voltage: 9.0 --- 16V DC Maximum starting current:15ARated working voltage:13.2V DC Rated current:3.2A damage rate : <0.5% power output:32 38W Startup characteristics 1 second to reach 60% brightness,6 seconds to the rated brightness, 20 seconds to a stable current. Over-voltage protection when the working voltage wasbigger than 16V, the product enteredinto self-protection state,protection current ≤ 0.06A. Low voltage protection when the working voltage wasless than 8V, the product will enteredinto self-protection state,protection current ≤ 0.06A. Short-circuit protection When the lamp output line was short-circuit, the product enteredinto self-protection state, protection current ≤ 0.06A. Output open-circuit protection When the lighting tube ruptured, the product enterdinto self-protection state, protection current ≤ 0.06A. Reverse Protection When the power wasnegative reversed, product wouldn’t work,Protecting current =0.00A. 4.HID check porojects Appearance:smooth surface without scratches, no deformation, damage, no broken links, non-deformation.Plug connection should be firm, not to loose.Insulation test:The insulation resistance of shell ≥ 100MΩ.Open-circuit test:output open, connected to 13.2V DC, high-voltage discharge output stop at 1-2 seconds,the product enterEDinto automatic protection state.Short-circuit test:output at short circuit state, connected to 13.2V DC, after 0.5-1 second,product enteredinto automatic protection state.Working current:connectedto 13.2V DC, cold start-up current ≤4.0A, stable current :3.2±0.1A. Hot start test:Continuous start up to 5 times after stable work for 5 minutes barrier-free,hot starting current:≤3.2A. Reverse test:connectedto 13.2V DC reversely, the product wouldn’twork. Overvoltage protection:When the voltage reach 18-19V, product enteredinto automatic protection state. Loss test:lighting tube power stayedat 35±1W, the loss of the ballast should be 6±1W. Surface temperature test:connectedballast with xenon lamp,light for an hour at room temperature, the ballast surface temperature should not exceed 60°C. Waterproofperformance:immerse the ballast in 100cm water at nomal temperature for half an hour, the ballast couldstill work. High and low temperature performance:the ballast couldwork at temperature -30°C +85°C.