食用油弹

edible oil dispenser A,Product application 1Suitable materials: Lubricating oil,engine oil, gear oil, antifreeze, coal tar, transformer oil, hydraulic oil, edible oil, mechanical oil, apply a wide range of fluids and viscous materials used in vehicle lubrication, commercial and industrial settings. 2,Materials viscosity range: 5-1500cst 3,Use of the environment: pumping from oil drum (the best) or pumping from the tank. 4,Applicable field: used to refuel lubricating oil to gearbox and driving axle in the production line of motorcycle or vehicle factory. B,Product Name: Electronic Lubricant Dispenser C,Model: JTSA111C-10502 D,Specifications: 1,. Flow rate range: 0.1L –0.5L/Min. 2,Maximum Permissible Error: ±0.3% 3,Single volume: 0-9999.99 Liter 4,Cumulative Total: 0-999999.99 Liter 5,Power supply: AC380V±15% 50Hz. 6,Motor power: 0.55KW 7,Ambient Temperature: -40°C--+100°C (electronic parts adopted temperature) 8,Noise Level: ≤70 dB(A) E,Function 1,Presetting and non-presetting function: the presetting function can also preset refuel times, e.g. if input refueling volume at first operation, it will refuel the same volume again in the following consecutive operation. 2,The cumulative total figure can be queried. 3,Remote control functions: when preset refuel times, it is not need to go back again to re-enter the volume. It will start to refuel the same volume by using remoter, which can be used in a radius of 20 meters of Dispenser. Refer to drawing. 4,Measure unit: volume. F,Control by Operator Panel on dispenser and Remoter, each one can be used along G,Products configuration: 1,Mobile type: Dispenser and oil drum is separate.With a separate mobile cart 2,Hose length is 5 m. 3,Inlet pipe: the length of hose between oil drum and dispenser is 2.5M; the pipe inside of drum is 1M; and also with single check valve. 4,Nozzle leakage-proof nozzle H, Options 1,Drum Heater :(refer to drawing)it consists Temperature Controller and Heating Belt. Drum Heater usage Heating belt is winded on a drum. It warms up automatically and can be controlled by temperature controller. It stops heating or starts to heat when temperature is up or below the preset level. Power supply 220v 50hz 2kw. 2,Drum Gauge due to the dispenser is without air separator, the drum gauge is installed on drum vent position to prevent refueling air. Drum Gauge function when the oil level is lower than 3cm, which is the distance to the bottom of drum, the dispenser stop automatically and give the alarm. 3,Please make sure the two options, before your ordering. If you need Drum Heater, please let us know where is the Drum heater (not heating belt) installed? on mobile cart or other position. I,To customers: when you decide model, please inform us 1. injunction port diameter. 2. length of refueling hose. 3. refuel volume. 4. material name and viscosity.