全球通遥控摄像机的。 原制造商的!

GSM remote camerais one of the simple image capture device.It uses a SIM card inside, makes use of GSM network and MMS image technology. You can control the camera and get MMS images anywhere by your MMS-enable mobile phone. It also supports motion detection, wireless alarm. If there is any motion within the camera area, the camera will notify you by calling, SMS, MMS or Email. It also can dial the preset alarm number once the sensor active.Advanced Functions:Wireless Monitor: Capture images and have it sent to your mobile phone. SMS Remote Control: Control the monitor by SMS command over the air. Wire tap live voice: Call the wireless Monitor number (SIM card) to listen in monitoring place live voice. Motion detection: Detect and alarm any motion within the monitoring area. Sensor detection: Max connects 15 sensors such as door magnet, infrared body sensor, smoke sensor, gas sensor etc. Any sensor active will active the monitor alarm. Infrared Light: Even in dark environment, monitor can capture images with the infrared light help. Special Camera: 300,000 pixel CMOS camera, get clear image. Receive images by mobile: The monitor will send latest MMS images to your mobile, you can see them anywhere. Receive images by email: The monitor can send latest MMS images to preset email, you can check them in your email. Multimode alarm: Alarm by SMS, MMS, or calling mode once danger happens in monitoring place. Alarm record: Automatically start voice record function once alarm active. Timing / manual monitor: Timing or manual setting the monitor according to users schedule. Remote control: Each monitor matches two remote controls, support one button emergency alarm. Infrared body detector: Integrate infrared body detector, only in set defense status, once any intruder approach to the monitoring area, the camera will alarm you as pre-set ways. Backup lithium battery: Make sure the monitor can continue to work if the external power cut off. Download user manual: User can download the manual anytime via SMS command.