PT-04 NE Wireless Flash Trigger

PT-04 NE Wireless Flash Triggeris with an umbrella holder,therefore there is no necessory to use a light stand bracket, and the flash effectiveness is the same as the item that is used with a light stand bracket. The remote trigger for studio flashes and outdoor flash is used as the controller of synchronous trigger studio flash of cameras. It consists of a signal sender and a receiver trigger and works by means of the frequency modulation wireless remote control. The signal transmitter adopts the advanced circuit and components, and can transmit the coded FM wireless signal. The circuit of the transmitter has the function of standby and hibernation, thus it has low power consumption; the products can work under the standby mode for more than one year with only one battery; continuously trigger for thirty thousand times. The trigger current is only 0.01MA, which will definitely cause no damage to the flash contact of the camera. The transmitter is applicable to the traditional or digital camera with hot shoe or PC controlling interface. Receiver trigger adopts dry battery for power supply, which is safe, energy-saving, and convenient. The product adopts micro-computer for controlling the decoding, Which has superior anti-interference capability; sensitive reaction speed, the highest synchronous speed can reach 1/500 sec. All the models of the product uniquely have the multi-frequency isolation technique and the self coding matching function by users. Users can freely match and use the sender and the receiver according to the demands, which have four isolated channels to suit for specific shooting environments. Triggers set in different channels can be combined to work or independently work but do not interfere with each other in an efficient distance. Specifications:TransmitterReceiverPower Source23AAAA x2Outdoor operating distance (open area)>30MIndoor operating distance>10MFrequency Channel4Operating FrequencyFM 433MhzOutdoor Synchronous Speed (open area)Max 1/500secIndoor Synchronous SpeedMax 1/250secTrigger times30000Transmitter standby time>1 year (new battery)How to use: Make sure the channel selector of both transmitter and receiver at same position. Insert your flash hot shoe socket into the receiver's hot shoe jack. Press the test button on your transmitter. The Flash should now flash. Insert the transmitter's hot shoe socket into your camera's hot shoe jack. If your camera does not have a hot shoe use a PC sync cord and insert into the socket.