M192个警卫卷组成机器

M 192 guard roll forming machine guard roll forming machine with simple structure, beautiful appearance, easy to install, high efficiency,low noise. The production flow of equipment of M192 guard roll forming machine: DecoilingFeeding(take the sheet to the first station)leveling----Punching of the sheet roll forming----hydraulic cut to lengthproduct packing manual The structure of equipment 1, Hydraulic decoiler l Single unrolling machine, one side can put material l Adopt automatic hydraulic system l Coil weight (Max):7000kg l Coil dia (Max):1600mm l Oil cylinder dia:1200mm working pressure: 10mpa l Coil Width(Max.):500mm 2, feeding, leveling l feed into unit oriented wheel(can right and left adjust) l into feeding roller, dia is 180mm,material 45# steel, quenched 48°-52°, chromed l leveling is three roller above and four roller below, quenched and chromed 3, punching (can right and left adjust) l using hydraulic punching l oil cylinder dia: 140mm l working pressure:20mpa l mould material: Cr12 quenched 58°-62° l hydraulic power:7.5kw l size: 1.5m long*1.1m wide*1.2m high 4,roll forming l main motor power: 45kw l Decelerating motor: BWD14-43-37kw, made in Shanghai or Changzhou l drive: gimbal driving,120*500 l main shaft dia: 100mm material: 45forge steel l roller material: GCR15 quenched 58°-62°,chromed l roll station:17stations l Timing by transducer:5m--20m/min(not including punching) 5, cutting l hydraulic cut l knife material: Cr12,quenched 58°-62° l oil cylinder dia:250mm l working pressure:30mpa l working journey: 80mm 6, the Outside size: l 18m long*2.2m wide*1.5m high 7, Run out table l Jointed by 60mm*40mm tube (can be adjusted to up and down) l size:1.5mlong*0.8mwide*0.6-1mhigh(can be adjusted) 8, Control panel (Panasonic) l Control system (1) Voltage, Frequency, Phase: 380 V, 50 Hz, 3Phase (2) Automatic length measurement: one unit tooling of length measuring which is lightly pressed on the surface of the steel sheet; the tolling will roll with the moving speed of the steel sheet and then sense to measure its length. (3) Automatic quantity measurement (4) Computer used to control length & quantity. Machine will automatically cut to length and stop when required quantity is achieved (5) Length inaccuracy can be amended easily. l Control panel: Button-type switch, LED display length and quantity l Unit of length: millimeter and inch (switched on the control panel) l Protection function (1) Motor Over-Load protection (2) System Over-Current protection (3) Short circuit protection l Additional function (1) Display total length produced (2) Display total quantity produced (3) Display forming speed. roll forming machine