glazed wall tile

Wall Tile, Floor Tile, Deco, Border ITEMRequire StandardThe Check ResultLength±0.5%- 0.24 0.09%Wideth±0.5%- 0.24 0.16%Thickness±10%3.4 6.9%Straightness of sidesThe excellent grade product ±0.2%0.05 0.07%RectangulartyThe excellent grade product ±0.3%0.04 0.06%The central bend degreeThe excellent grade product ±0.2%0.30%The side bend degreeThe excellent grade product ±0.16%0.2 0.3%The warp degreeThe excellent grade product ±0.1%-The surface qualityExcellent product: At 95%bricks have no bugs when watch it from 0.8mm away uprightlyAccordWater absorptionThe average value E>10%, single value ≥9%14.9 14.6%Breakage pressureWhen the thick ≥7.5, the average value≥600 (N)978.4(N)Modulus of breakageThe average value E≥15, single value ≥12 (MPa)22.5 21.4(MPa)Resistance to thermal shockWithout crack and flaw after 10times anti heat shock testAccordResistance to glaze crackingWith any flaw and peel of the glaze though the anti glaze flaw testAccordThe family chemical reagent proofNot lower then GB gradeThe GA gradePollution-proof abilityNot lower then 3th gradeThe five gradePacking and signMust be according with the provision of the 7th and 8thAccord Safe And Health Building MaterialsAntifouling:Quadratic calcinations lasting for more than 200 minutes at a high temperature, super low water absorption. Extremely small pores in tiles surface is difficult for the blots to infiltrate into the product.Antistatic:Acting with antistatic function, the product is applicable to the decoration of the floor and wall of all the places with antistatic requirement.Need-to-know of Usage of Houses Ceramics1. This product is an ideal product for interior decoration (ceramic glazed tiles for internal wall) and not suitable for the application of exterior decoration. Please use the tiles which are of the same size and color number, in case any piece of tile which is of different size and color number, please use it separately.2. Before the tiling, please use clean water to soak the tiles (it is inadvisable to soak the tiles together with the carton), pick up the tiles and use them when no water spot remain on the surfaces of the tiles.3. When tiling, cement with lesser acid content i.e. #275 cement (or 1:0.15 cement lime mortar) is recommended, plaster the cement or mortar evenly on the back side of the tile then tap the tile surface with a wooden hammer to secure flatness and avoid untight laying of the tile.4. After finish laying the tiles, it is strongly recommended to point deeply the joints and wipe off the cement remained on the tile surface to make it clean, it would be better to point the joints with white cement after the aforesaid pointing slightly dries.MaintenanceType of dirt Detergent Lime residue Acid detergent Ice cream Alkali detergent Grease, oil Alkali detergent Rust Hydrochloric acid or phosphoric acid Ink marks Diluting sodium hypochlorite Mark pen Organic solvent (acetone triethylene) Coffee, juice Diluting sodium hypochlorite (bleaching powder)