FZC Vibrating feeder(multiple choice)mining feeder

USES: XLZ series Vibrating feeder is a kind of mine in vibration motor excitation source for yaw-roll-pitch strikeout inertia vibration and equipment, widely used in metallurgical, chemical, building materials, such as coal mining. Ore and other materials is released, feeding or loading of the ideal equipments. XLZ series ore machine features: 1, save energy and high efficiency, the ore mines and easy control, 2, equipment manufacturing, installation simple small quantities, low cost, 3, due to the large reduced vibration of suspension arch, ore, 4 and can effectively prevent moisture content of ore mines run, 5, application scope, strong adaptability. Vibration of environmental conditions and requirements are as follows: 1, the environment temperature is not more than 40 ° c + + 2, air relative humidity is not more than 90% 3 and can be used in dusty and extremely large amount of ore fluctuations are uploaded. Using and maintenance: Proper use and maintenance of vibration and machine is long and vibration machine that the normal operation of the important factors. 1, before work, must check vibration motor and base bolt looseness (where stress is big, easy to loose bolts fracture), and even in fastening bolts, guarantee. 2 and check whether good sealing, seal welded, whether I should, if leakage welding welding sealing materials, prevent scatter influence, the normal operation of motor, so that the motor overloaded burnt out. 3 often, under the counter, scattered materials under the counter has enough vibration space. 4 and stopped by mine machine in place, can run after the ore vibrating machine. 5 and avoid vibration. Air is the motor of bolt looseness overload, weld cracking of the important reasons for the accident, installation and debugging of load test, when the excitation motor shall be transferred to a minimum, or to just a few vibration damping force of spring, in order to avoid excessive make bedplate and vibration. 6 and long-term parking or motor damp, must pick 36V power, dried up, preheat the start-up working. 7 and when not working, the operator of mine machine, parking, must pull switch, cut off power supply. 8 and power cannot around our should be reserved, not less than 80mm headroom, fixed in the stillness of the near motor on the leg.