Fiberglass rock bolts pultrusion line

MG-26 FRP rebar pultrusion line Fiberglass rock bolts pultrusion lineis used to produce FRP rebar with different specification. It can finish distributing yarn, dipping glue, pre-molding, winding, heating and hardening, traction, set-length cutting and pile up automatically. Equipment Characteristic: This line mainly consists of yarn support, dipping glue slot, winding, dry oven, haul-off machine, cutting saw and tilt tipping device. Yarn support: used to place the yarn spool, adopts the welding structure of steel plate, steel pipe and angle iron. Dipping glue slot: welded by stainless steel material, there is press roller inside to make the roving dip in the resin sufficiently. Winding device: adopts gear wheel to drive the roller turn around the products, and wind the thread. This device adopts frequency conversion speed-regulated mode, adjust the rotate speed stepless. Dry oven: adopts cast aluminium heater, intelligent temperature controller to control the temperature. The heating box adopts mesh structure and it is easy to open it and clean the dropping resin, filled with insulation materials inside. Technical parameter: Working voltage 380V/50HZAir pressure 0.4-0.6MpaGeneral power 20KwCenter height 1000mmNumber of winding heads 2Winding diameter Max. 26mmWinding rotation speed 9-95rpmTraction force Max. 40KnTraction speed 0.1-1m/minClamping width 500mmClamping length 1200mmCutting speed 2850rpmCutting range (W*H) 600*65mmLength setting mode Limiting switchCutting journey 700mmDimension 20000*1850* 1450mm