E1 to 10/100M Ethernet & V.35 Converter

E1 to 10/100M Ethernet & V.35 Converter Overview FBPC100 Series gives the interface conversion between G.703 E1 and V.35. This device provides an economical digital access solution for E1 and Fractional E1 network services. With a adapter cable, the Device can link to other DTE Device, such as router, at data rates of 64Kbps to 2048Kbps. User data is placed into the E1 frame, using only the required number of timeslots. Timeslot assignment is accomplished according to the Data Port speed and manual setting of DIP switches.FBPC100 Series is widely used in communication network, both in WAN and LAN connection field. Features Interface conversion between E1 and V.35, E1 and Ethernet Support ITU-T V.35, G.703, G.704, G.823 Fully compatible with IEEE 802.3 and Ethernet Standards Standalone and chassis module available, support hot-swap Framed (N*64Kbps) and unframed (2.048Mbps) optional, support continuous and discontinuous timeslots setting Ethernet port 10Mbps, Full/Half Duplex mode compatible 10Base-T LAN Interface on RJ-45 connector and MDI/MDI-X auto-crossover Frame mode support PCM30/ PCM31 CRC/non-CRC auto-negotiation on E1 interface Support remote bandwidth control, and remote loop back under framed mode. Support internal clock, E1 recovery clock or V.35 line clock Provide local, diagnostic and remote loop back test. For E1 interface, 75 ohm (unbalanced) and 120 ohm (balanced) available and auto-negotiation. For V.35 interface, DCE and DTE mode are optional Comprehensive LED indicators on front panel, convenient for the diagnosis of equipment working state Management Support Console, WEB and SNMP management Provide Timing Mode Setting, Loop back mode setting, Framed or Unframed mode setting clock resources selection, and etc. Provide environment parameter monitoring, including power supply status and device operation temperature Show details of system information, including Chassis name, location information, IP address, start-up time, software and hardware version View & configure the working status of local and remote device, including connection status, port status Provide user management to ensure the device operation security Specifications E1 ports Compliant with: ITU-T G.703, G.704, G.823 Rate: 2.048Mbps Code type: HDB3 Impedance: 75 ohm unbalanced & 120 ohm balanced optional Physical connector: BNC for unbalanced & RJ45 for balanced V.35 interface: Compliant with V.35 standard Rate: n×64Kbps, n=132 Physical connector: DB25 female jack DCE & DTE optional Ethernet ports Compliant with: IEEE802.3, 802.3u, 802.3x Rate: 10Mbps, Half/Full auto-negotiation Auto MDI/MDI-X Physical connector: RJ45 Environment Operation Temperature: 0 50 Operation Relative Humidity: 0 90% Store Temperature: -20 65 Store Relative Humidity: 0 95%