Alumina ceramic lining brick

APPLICATION:The alumina lining bricks are used as the lining in the ball mill of ceramic industry, cement Industry, paint industry, color industry, chemical industry medicine industry and coating industry. Using this liner will effectively improve grinding efficiency, reduce grinding cost, and it is considered to be the best choice for ball mill lining.TECHNICAL DATA OF LINING BRICKItemsCN70CN80CN90CN93CN95Specific Gravity g/cm32.95 3.023.33 3.363.55 3.603.63 3.683.70 3.75(Mohs Scale)Hardness8.58.5999Compression Strength MPa≥1700≥1800≥1850≥2000≥2250ColoryellowishWhiteWhiteWhiteWhiteEquivalent Wear Loss≤0.18‰≤0.14‰≤0.10‰≤0.08‰≤0.05‰ STANDARD SIZESItemL mW1 mmW2 mmH mmHi Al2O3 Straight Brick 15050/40/50/60/70Hi Al2O3 Trapezoidal Brick 150504540/50/60/70Medium Al2O3 Straight Brick 16040/60/70/80/100Medium Al2O3 Trapezoidal Brick 160403560/70/80/100ADVANTAGE ANALYSIS: (1)AL2O3 is the main content,high purity.(2)Fine Wear Resistance, 1/4 to natural liner.(3)High purity ,thinner slurry.(4)Fine corrosion resistance, high density, high mechanical strength GUIDANCE FOR USING: Calculation of alumina liner installed in ball mill 1. The number of alumina liners installed on two end walls: (1) Calculation of the number of straight liners on the end wall: Gf=3.14×r2÷(L1×W) in the above formula: Gf: the number of straight bricks on the end wall of ball mill r: the semi-diameter of the end wall of ball mill W: the width of lining bricks L1: the length of lining bricks (2) Calculation of number of semi-straight bricks on the end face: GB=D÷W In the above formula: GB: the number of straight bricks on the end face. D: the diameter of the end wall W: the width of alumina liner 2. The calculation of number of liner on the round wall. The total No. of liners: GC=R1×R2 , R1=3.14×D÷W , R2=(L-2h)÷L1,in the formula: GC: The total number of straight bricks and trapezoidal bricks on the round wall. R1: the rows of bricks on the round wall. R2: number of bricks in each row D: the diameter of the end face h: the thickness of liner L: the length of Ball mill W: the width of alumina liner L1: the length of liner Remark: GC: calculation of the total number of straight bricks and trapezoidal bricks according to tonnage of Ball mill according to the following table. Respectively calculate the No. of straight liner GC1 and trapezoidal liner GC2 according to the proportion in the table.Mill Tunnage0.3T0.5T1--1.5T2.5--3T5--25T30--40 TStri. Brick:Tra.Brick0:11:101:12:13:15:13. The total No. alumina liner: Straight Liner=2Gf+ GC1 Trapezoidal Liner = GC2 semi-Straight Brick=2GB+ GB1 semi-trapezoidal Brick= GB2 Flake Brick= R2