AC/DC Power Supplies

AC/DC Power Supplies S-15 Series:Switching Power Supply1.Low price and high reliability 2.105 output capacitor 3.AC input power suitable for the world 4.High efficiency and low operation temperature 5.Soft-start current can reduce the AC input impact effectively 6.With short-circuit and overload protection 7.Compact size, light weight 8.100% full-load burning test 9.Installed with EMI filter, minimum waveModel Specification S-15-5 S-15-12 S-15-24 DC output voltage 5V 12V 24V Output voltage error (Note2) ±2% ±1% ±1% Rated output current 3A 1.3A 0.7A Output current rage 0-3A 0-1.3A 0-0.7A Wave and noise(Note3) 50mVp-p 50mVp-p 100mVp-p Inlet stability(Note4) ±0.5% ±0.5% ±0.5% Load stability(Note5) ±1% ±0.5% ±0.5% DC output power 15W 15.6W 16.8W Efficiency 65% 68% 72% Adjustable range for DC voltage ±10,-5% ±10% ±10% AC input voltage range 85132VAC/170264VACselected by switch Input current 0.5A/115V 0.25A/230V AC impulse current Cold-start current 15A/115V 30A/230V Leakage current <0.5mA/240VAC Overload protection 105%150%Typecurrent limiting; Reset: auto recovery Over-voltage protection High-temperature protection Temperature coefficient ±0.02%(050) Setup rise hold up time 200ms,100ms,30ms Vibration 10500Hz,2G 10min./1cycle,Period for 60min,Each axes Withstand voltage Input and output interval1.5KVAC,Input and enclosure1.5KVAC,Output and enclosure0.5KVAC Isolation resistance Input and output interval,Input and enclosure,Output and enclosure0500VAC/100M Ohms Working temperature and humidity -10+60,20%90%RH Store temperature and humidity -20+85,10%95RH Overall dimension 99*97*35mm Weight 0.3Kgs Safety standards Meet UL 1012 requirement(Not apply for the mark) EMC standards Meet FCC Part 15J Conduction Class B Note:1.The testing condition for the parameter above is:230VAC input, rated load,25 70%Rh,Humidity 2.Error,include the setting error, line stability and load stability.(Note:5) 3.Wave test:adoptingA12double wire for 20MHz,and 0.1uF&uF capacitor short-circuit for interrupting 4.Inlet voltage stability test: when is over load, the lowest voltage of inlet is representative to the highest voltage. 5.Load stability test: The load is from 0% to 100%,others 60%. 6.C2311must be knocked down.