36W紫外线灯

36W UV Lamps (BS-0013) Instructions for Use Model: Fluorescent tube table lamp with two internal,conventional chokes (2x9 Watts each) Technical data: Power input: 4 x 9 Watt Operating nominal voltage of the tubes: 70 Volt / 50Hz Primary stress of the chokes/mains voltage: 230 Volt (We can also produce 110V according to your request.) Start-up: Push mains plug into socket (220V-240V/50Hz). Press operating switch (red switch) at the back of the machine. The tubes switch off automatically after about 2 minutes. Shutdown: Disconnect lamp from the mains supply when not in use (pull plug Out of the socket). Appropriate handling: Place your hand in the lamp.When working with UV gels,please follow the instructions of the gel supplier.In general, the length of radiation needed to harden a UV gel in layer of 2-3 mm thick is approx 120 seconds If a technically perfect gel does not harden sufficiently, it may be necessary to replace the fluorescent tubes.We recommend that our specialists carry out the replacement.if not,we recommend the following procedure: Fist switch off the lamp and pull the plug out of the socket.Pull the tubes out of the plug- in socket along the longitudinal axis(snap-in lock) and then put the new tubes in accordingly.The tubes must fit into place with an audibe snap.please dispose of the old fluorescent tubes in the containers especially provided. Packing detail: Carton Dimensions(CM) :50.5 X 31.5 X 36 6PCS/CARTON BOX Net Weight: 11.05KG Gross Weight: 11.80KG