30x60,30x45,20x30,250x330 Ceramic tiles

Ceramic wall tiles,ceramic tiles,tiles 1.Size wide range 2.W.A.:6-15% 3.Good price, Good quality 4.Matt or Glossy Packing detailsSIZECartonPalletPCKGSQMCARTONKGSQM200x30025171.5721224108250x33020211.6572/541512/1134118.8/89.1300x45011251.48548120071.28330x6008311.58448/361488/111676.03/57.02 Inspection ReportTest Basis on ISO13006Item No.: 30290Test DescriptionTest MethodISO13006 BIaTest ResultLimitSurface (CM2) ss>410Length and Width The manufacturer shall choose the work size as follows: a) for modular tiles in order to allow a nominal joint width of between 2mm and 5mm1); b) for non-modular tiles so that the difference between the work size and the nominal size is not more than ±2%(max. ±5mm). The deviation, in percent, of the average size for each tile (2 or 4 sides) from the work size (W). ISO10545-2600±1.0600.1 600.4The deviation, in percent, of the average size for each tile (2 or 4 sides) from the average size of the 10 test specimens (20 to 40 sides).ISO10545-2±0.5%/Thicknessa) The thickness shall be specified by the manufacturer.ISO10545-2-/b) The deviation, in percent, of the average thickness of each tile from the work size thickness.±5%/Straightness of sides (facial sides) The maximum deviation from straightness, in percent, related to the corresponding work sizes. ISO10545-2±0.2%-0.03 +0.04%Rectangularity The maximum deviation from rectangularity, in percent, related to the corresponding work sizes. ISO10545-2±0.2%-0.02 +0.03%Surface flatness The maximum deviation from flatness, in percent:a) central curvature, related to diagonal calculated from the work sizes;ISO10545-2±0.2%-0.04 +0.04%b) edge curvature, related to the corresponding work sizes;±0.2%-0.04 +0.06%c) warpage, related to diagonal calculated from the work sizes.±0.2%-0.05 +0.04%Surface QualityISO10545-2A minimum of 95% of the tiles shall be free from visible defect that would impair the appearance of a major area of tilesConformedWater absorption Percent by massISO10545-36<E≤10% When the average exceeds 20%.this shall be indicated by the manufacture 6<E≤10% When the average exceeds 20%.this shall be indicated by the manufacture Breaking strength, in Na) thickness ≥ 7.5mmISO10545-4Not less than 600807.4N b) thickness < 7.5mmNot less than 200/Modulus of rupture, in N/mm2 Not applicable to tiles with breaking strength ≥ 3000 NISO10545-4Minimum 15 Individual minimum 1219.6MPa 18.0 23.6MPa