安全警报上了锁

Lock Features: .110dB siren .Auto-alarming system & locking system .Can be used alarmed or without alarm .Two tone alarm .Automatic reset .Shock & Movement Sensor .Corrosion Resistant .Weather resistant .Anti–muffle design .Hot processed hardened Stainless steel & Anti twist shackle .Hardened Zinc alloy body .Alarm under water, waterproof Dimensions: .Height: 9.5Cm .Width: 9.5Cm .Depth:3.0cm .Shackle diameter: 10mm Secruity alarm padlock Alarming and Disalarming Unlock your padlock and remove the shackle. There is a deep groove on the inside edge on one side of the shackle. When fitted with the groove on the key port side of the lock, the alarm is active-as you insert the shackle the unit will beep. If fitted the other way round the alarm system is inactive and when you fit the shackle this way round the unit will not make a noise. Disable the alarm when using on moving vehicles and change the shackle position to set the alarm when the vehicle is stationary. Operation Insert the key and turn clockwise to release the shackle and re-fit the shackle with the groove near to the key port. The lock will beep to indicate that the alarm is active. The padlock will be armed after 30seconds. Turn the key anti-clockwise to lock the unit. The first time the alarm is triggered the unit will provide a tripe beep warning. This allows you to unlock it without setting off the alarm. The next trigger will cause an alarm. To turn off the alarm, unlock the padlock and remove the shackle The two tone 110db siren will sound for ten seconds when triggered and will sound again if triggered again. After 35 seconds without a trigger, the padlock will reset so that a further trigger will give the triple beep warning before alarming. Battery replacement To replace the batteries, remove the shackle and carefully undo the two screws at the bottom of the shackle holes. Pull the padlock apart, carefully open the battery cover and replace the batteries. Do not lose or damage the rubber washer on each screw. This alarm requires 6x LR44 1.5V cells Make sure you insert the batteries with the correct polarity. In normal conditions batteries should last up to 6 months or over 2000 ten seconds alarms.