В открытом состоянии холоднокатаная Раздел Формирование Mills

1)Technical flow First, the coil of strip is suspend to coil car for preparing stuffing by overhead crane, the coil car with coil of steel strip is carried to uncoiler, then coil car runs its oil cylinder vertically to make the center of steel strip aim at center of wimble head of uncoiler, which can hold the coil of strip steel; When coil is hold, coil car will be withdrawal to preparing position for the next time. Then, drag roll of flattener falls and impacts into steel coil, the wimble of uncoiler circumrotates, at the same time shovel head of flatter swings, uplifts, put out for clinging to steel coil. The end of strip steel is scooped up through indenter oil cylinder work, assorting with that wimble head to-and fro circumrotates slightly, which will level the strip steel head. The wimble continues to round; strip steel is carried to flattener. Withdrawal rolls chimp strip steel head; gyro-withdrawal rolls carry strip steel into five-roll flattener, which will flat strip steel by to-and-fro moving. Strip steel flatted is carried into shear weld, the head and trial of strip steel is sheared to align, then is carried to weld platform and is weld via gas protection weld, strip steel weld is carried to accumulator for reserve. 2)Technical Specifications: No.ModelSizeThickness(mm)Roll Weight(t)Forming Speed(m/min)Installed Capacity(kw)1LW20020×20 50×501 3520 809002LW60060×60 150×1502 71020 6014003LW80080×80 200×2002.5 101520 4016004LW1050100×100 250×2503 12.72015 3026005LW1250120×120 300×3003 143010 2532006LW1400150×150 350×3504 14308 2036007LW1600200×200 400×4004 16308 1539008LW2000250×250 500×5004 20408 154200