UXP300 серии Мощные резисторы

UXP300 series Power resistors Mainly used as a snubber resistor to compensate the C-R peaks in traction power supplies. General Characteristics Electric support:High alumina ceramic metallized on the top side with EBG Metoxfilm placed on a solid A1 heat distribution plate for perfect connection to the main heat sink. Encapsulation:Special resin filled epoxy casing with large creeping distance to mass, large air distance between the terminals and high insulation resistance (CTI 600). Resistance Element:Special design for perfect current yield over the entire resistor area. Contacts:Easy load connecting with M4 or M5 screws. Connector height (M+N) available from 25 to 42mm.Various sleeves for increased creeping distance up to 85mm or potted cable connections are available on special request. The model UXP 300 introduced on this page can be changed according to customers specification. Please note that almost all of our UXP customers have their own custom designed drawing. Therefore please do not hesitate to discuss your special need with the local representative of EBG. Resistance Values:0.5Ω to 1MΩ Resistance Tolerance:±5% to ±10% Temperature Coefficient:±150ppm/°C (others upon request) Maximum Working Voltage:5,000VDC; higher voltage on request, not exceeding max. power Short Time Overload:1.5x rated power = 450W at 70°C for 10 sec, ∠R = 0.4%max. Power Rating: 300W at 85°C bottom case temperature. Electric Strength Voltage:6kVrms, 50Hz,1Min.,up to 8,000Vrms on special request Single Shot Voltage: up to 12kV Normwave (1.5/50 μsec) Partial Discharge: 3kVrms<10pC, up to 5kV on special request Insulation Resistance:10GΩ Min. at 500V Creeping Distance: 42 mm Min. Air Distance:14 mm Minimum Inductance: 80nH Capacity/Mass: 110pF Capacity/Parallel: 40pF Operation Temperature:-55°C to +150°C Max. Torque for Contacts: 2 Nm Max. Torque for Mounting:1.8 Nm M4 screws