Светодиодные подземный фары

Made up of RED, GREEN and BLUE high power LED, the inground lights can realize more than 16,770,000 kinds of color output, and with great effect and colorful features. It adopts wires with 4pin connectors, and work with 4-wire and 3-loop controller,which can achieve Gradual Change, jumping and many good light effect. With IP67 rank and-20°C 45°C working temperature,the inground lights can adapt to a variety of indoor and outdoor temperature, humidity difference. They can be widely used in decoration of the buildings, stage, ancient buildings, shopping malls, hotel, cultural place and so on. The inground lights should be work with 4-wire and 3-loop controller,Simple DMX controller ( Please refer to the instruction for operation ) With a remote controller, 4-wire and 3-loop controller can be chose single mode optical efficiency, total 13 kinds, and also it can stteing the address of the controller to accept DMX signal and control the brightness. However, Controller drive capability is limited,eg. The max data if the 12V 10A remote RGB controller can drive is 120W(=12V*10A)inground lights, and take 3.8W( max power ) 1*3W RGBinground light as another example, the controller just can drive 31pcs(120/3.8≈31). The maximum number of connections power of other inground lights calculated in this way.RGB amplifiers are needed when you want to connect more lights together. Attention 1.Please follow the "use environment" requirements 2.The inground lights work with 4-wire and 3-loop controller or Simple DMX controller, could not work without RGB controller 3.Please choose the Adequate power supply according to the total power if the lights 4.Three addresses for each RGB controller, the first simple DMX controller or 4-wire and 3-loop controller added by three is the address of next simple DMX controller or 4-wire and 3-loop controller 5.The inground lights series connected with the same 4-wire and 3-loop controller or Simple DMX controller are with the same change effect 6.The Maximum address of the 4-wire and 3-loop controller or Simple DMX controller is 510 7.Please follow the illustration of conection when connect many lights 8.To ensure the good control, please add amplifiers when the distance is more than 100meters. Installation Guide 1.Make sure the power supply of housing to connect ground 2.The power and signal output wire of the last light in each loop connected waterproof cap 3.Make sure the controller and power supply to work in ventilated, dry environment 4.Please make sure no short-circuit before using, or the components may be burned Technical parameters Part. No. IN2E11/IN2C11/ IN2B11/IN2D11 IN2E13 IN2E16 IN2E19 Rated Voltage(V)DC12DC12VDC24VDC24VMaximum power(W)3.8914.426.4Maximum Current(mA)320 mA750MA6001100Controlling system4-wire and 3-loop controller,Simple DMX controllerStandard lens 25°/45° Light sourceRGB3in1 3W LEDWhite light flux(LM)52140254441Standard length of left wires250mmIP rankIP67