спираль классификатор

Spiral classifier is widely used to pre-grading and inspection grading in closed circuits when used in the production flow of metal processing. According to the difference in sedimentation rate of mineral particles and mud, the particle sizes of ores with 1.5mm-0.03mm are classified. Waste mud or water for ore sand can be separated from the ores. It’s also usually applied to ore washing, desliming and dehydration and so on. Spiral classifiers are divided into single spiral classifiers and double spiral classifiers. Beside, they are also divided into high weir spiral classifiers and submerged spiral classifiers. If the overflow edge is higher than the center line of spiral shaft and lower than the external diameter of spiral at the overflow end, the spiral classifiers are high weir ones. If the overflow edge is higher than the center line of spiral shaft and also higher than the external diameter of spiral at the overflow end, the spiral classifiers are submerged ones. High weir classifiers are usually used for the classification with particle size of below 0.2mm. Submerged classifiers are usually used for the classification with particle size of below 0.05mm. Structure and working principle Spiral classifier is composed of transmission mechanism, (left, right) spiral water tank, lifting device, lower support, lubricating device, ore discharge valve, feed inlet, etc The water tank of this machine is installed obliquely. The angle of inclination is determined according to equipment configuration of equipment in the process flow. The (left, right) spirals driven by the transmission mechanism rotates in the water tank. The finely grained slurry enters the water bank from the feed inlet at one side and forms one slurry precipitation zone, whose surface area and volume depends on the value of the water tank’s inclination angle and the height of overflow edge. The spirals rotating at a low speed play a certain stirring role. After the slurry is stirred, the light and fine particles float above the surface and overflow from the overflow edge. Then they flow into the next working procedure of ore dressing. The heavy and thick particles sink into the bottom of the water tank and become return sand which is transported by the spirals to the ore discharge mouth for discharge. If ore grinding and classification are closed loop operation, the return sand discharged from the ore discharge mouth still goes into the mill for further grinding. Classifiers normally form closed loop operation together with mill. Features simple structure, reliable working conditions and convenient operation. Because different grains have different specific gravity and sedimentation rates in liquid, this product allows the fine ore to flow in the water, while coarse ore sinks to the bottom. Technical Parameters Model30050075010002-150020002-2400TypeHigh-Weir,Sank Type,Single Spiral,Double Spiral ,Extended TypeSpiral Diameter (mm)3005007501000150020002400Spiral Rotational Speed (r/min)83 228 15.52.4 9.91.6 7.42.6 63.6(5.5)3.6Capacity (m3/d)Returnning Sand35 10554 260100 445130 7002240 53603240 594013600Overflow10 30135 7731 16350 1604604001160MotorTypeY90L-6Y90L-6Y132S-6Y132M2-6Y160M-6 Y90L-4Y160-4(6) Y90L-4Y225M-6Y100L2-4Power(kw)1.11.535.57.5 1.515(11) 15(3)303Quantity11112 21 122Size (mm)Length3844548067208004102701059012710Width64594012751570349046345430High835127415841934408044915690Weight (kg)Machinery Body66815752683420022093199305690Motors27376584240200