SMC / BMC смола

FL-9508 FL-9508 resin is specially fomulated for SMC/BMC application. The main raw materials is isophthalic/NPG. It was diluted in styrene monomer. It has high-reactivity, good mechanical and stable thicknable properties. With FL-LPA Low Profile Additive, FL-9508 resin can get classA surface. It was widely used in parts for automobile, electrical part and construction etc. Properties of FL-9508 resin(specifications) (Viscosity and reactivity undergo slight changes in the course of prolonged storage) Property Value Unit Test methodAppearance Clear Acid value 9.5-17.5 mgKOH/g GB/T 2895 -2008 Non-volatile matter 62-68 % GB/T 7193 - 2008 Viscosity at 25°C 1.43-2.39 Pa.s GB/T 7193 - 2008 Stability at 80°C 24 H GB/T 7193 - 2008 Typical cured functionUnit Test Method25°C water bath, 2ml MEKP, 4mlCo2+ 100 g resin Gel time 3.43-6.37 min GB/T 7193-2008 80°C water bath, 1g BPO,+ 100 g resin Gel time 9.60-17.84 min GB/T 7193-2008 65°C-Tmax 6.85-12.70 min Tmax 220-240 °C Properties of cured FL-9508 resin(typical values) (Determined on unreinforced and unfilled specimens) Property Value Unit Test method Appearance No defect Barcal Hardness 50 GB/T 3854-2005 H.D.T. 130 °C GB/T 1634-2004 Elongation of break 2.0 % GB/T 2567-2008 Tensile Strength 65 Mpa GB/T 2567-2008 Tensile Modulus 3400 Mpa GB/T 2567-2008 Flexural Strength 120 Mpa GB/T 2567-2008 Flexural Module 4000 Mpa GB/T 2567-2008 Impact Strength 9.0 KJ/m2 GB/T 2567-2008HANDLING: FL-9508 resin contains ingredients that could be harmful if mishandled. Contact with skin and eyes should be avoided and necessary protective equipment and clothing should be worn. STORAGE: Drums-store at temperatures below 25°C. Storage life decreases with increasing storage temperature. Avoid exposure to heat sources such as direct sunlight or steam pipes. SHELF LIFE: This product has a limited shelf life. When stored in accordance with the above conditions, this product has an average shelf life of three months. The test is according to GB. The information submitted in this publication is based on our current knowledge and experience. In view of the many factors that may affect processing and application, these data do not relieve processors from the responsibility of carrying out their own test and experiments; neither do they imply any legally binding assurance of certain properties or of suitability for a specific purpose. It’s the responsibility of those to whom we supply our products to ensure that proprietary rights and existing laws and legislation are observed.