Шнек и червячный привод редуктор

Worm and Worm Gear Speed Reducer Reducer 1.widely used intubines,shaft liners and axletrees;good resistance to wear,with high precision in dimensions,low noise,advanced centric running castings. 2.with air vent and high precision.< br /> 3.The structure is compact and the weight is large. 4.Packing:wooden cases or can be according to customer,s requriements. speed fo input shaft:1500r/min Trademark :GUOMAO notice of insallation 1.1 the base plate must be plane and stoutness and the base plate must be screwed down and shock proof. 1.2 The connecting shaft of prime mover,reducer and operation device must be coaxial installation. 1.3 The diameter tolerance zone of input and output shaft is H6,the holes of fittings must properly mate the shaft,which prevents bearing from breakage because of over-loose mate. 1.4 Drivers such as sproker wheel and gear must fitted close to bearing in order to reduce bending stress of handing shaft. 1.5 While assembling motor ofNMRV reducer.it is necessary that proper amount of butter applies to the warm shaft input hole and the keyway,avoiding assembling too tightly and rusting after using for a long time 1.6 When ordering of all using all kinds of wpd type,if the motor weight is binger than the common,supporting set is required. 2 notice of usage 2.1 before using,please check carefully whether the reducer model,,distance,ratio,input connecting method,output shaft structure, input and output shaft direction and revolving direction accord with requirement. 2.2 according to the requirement of selecting lubricant iol the product manual.Please fill proper category and brand lubricant and then screw on the vent-plug,unclock the small cone-plug of vent-plug.omly after doing these,reducer is already for starting up running.