RO Оборудование систем

Equipment features A General The equipment makes use of reverse osmosis membrane to produce purified water in compliamce with requirements of vaious pharmacopoeias across the world. Inclusive of pre-treament apparatus, heat exchange system, 1 pass RO purifiers and seterilization unit, it features easy operation, stable water output, desirable targets, and is widely used in the production of purified water. B Based on URS, our company will be responsible for the following l Design and calculate l Equipment manufacture,proper material selection l Test and inspection, and relevant reports l Packing, transportation and insurance l Equipment installation instruction, and installation, debunking on the part of seller l DQ,IQ,OQ documents l Relevant training on application and maintenance l After-sales service Our company will be responsible for equipment design, manufacturing, on-factory testing, on-site installation instruction and final testing. We also bear the responsibility of traceability on material, parts and equipment. C Equipment properties 1. Output water quality : conform to standards from both China and European Union Water system inspection targets ItemChinese pharmacopoeia(2005)European pharmacopoeiaPWWFIPWWFIPH Add 2 drops of methyl red without showing red, add 5 drops of bromothymol blue without showing blue5.0 7.0--Ammonia 0.000003%0.000002%--Chloride 2mol/L--Sulphate 0.008mg/L--Calcium salt 0.0098mg/L--Nitrate 0.000006%0.00002%Nitrite 0.000002%--Carbon dioxide 0.04mol/mL--readily oxidizable substance 0.1ml(based on 0.02mol/L chameleon solution)In compliance with specificationsNon-volatile matter 1mg--Heavy metal Less than 0.00003%Less than 0.00001%TOC --0.5mg/LConductivity --4.3us/cm(20°C)1.1μS/cm(20°C)Microbial limit 100CFU/mL10CFU /100mL100CFU/mL10CFU /100mLEndotoxin --0.25EU/mL--0.25EU/mL Note: under European pharmacopoeia regulation one is allowed to monitor either TOC or readily oxidizable substance only . Finished water produced through our equipment comes with a conductivity less than 1.3 μS/cm. 2,System output capacity: 6 m3/h(based on water with a temperature of 20°C). D Raw water information: 1, Raw water : refer to water analysis report sent by end user. 2, Water consumption: water needed for operation more than 9.5m3/h, back-washing cycle around 2 hours. 3, Water feeding pressure: water from external source comes to raw water tank with pressure between 0.1 0.3Mpa. Users are required to place raw water pipe in the equipment range, and to insatll main feeding valve for easy control. 4,Power supply: Air switch should be available to the water processing system, next to the electric control box, requirements are as follows: Power conditions: 220V/3ph/60Hz;