Регулятор уровня DF-96 серии воды уровень SW / вода

Water level controller Water level switch float level switch Indications and usage This Fluid Level Controls adopt integrated circuit, it designed according to the water level grade promote of up and down water pool (tower), and can combination control of up and down pool, pool water draining, short of water protection, it can automatic water-make up, draining, and prevent the pool water high enough to spill or spill idling damage effectivly, it used in many areas, such as industry, house, county, school, mining industry, enterprise and other water pool, water wells, and it widely apply to dyeing and finishing, chemistry, food, drinks, sugar production or other areas. Performance Indicators Type DF-96A DF-96B DF-96C DF-96D Outline 126*88*51mm 126*88*51mm 126*88*51mm 50*100*74mm Operating voltage 220V 220V 380V 220V Load current 16A 16A 10A 16A Consumption power ≤5W ≤5W ≤5W ≤5W Installing Hanging on wall Hanging on wall Hanging on wall Guide rail Installation Intruduction Single control upper pool water level control probe installation intruduction A (red line)Is the upper cistern or water tower's top water level control point,when the water reached A point, the probe touch the water level, then the controller shutdown the pump. B (blue line)Is the upper cistern or water tower's low water level control point,when the water has fallen bellow B point,the probe B out of touch with water,the controller open the pump,and the water level rise to A point. C (black line) C point against bottom of the upper cistern or water tower,contrat with the bottom of cistern or water tower. D (green line),E(yellow line) conected to line C Single control down pool water level control probe installation intruduction shown as PIC 2 A,B do not need to connect. C is the cistern ground line,keep against the bottom of the cistern. D Is the cistern's low water level control point,when the water level below the D point,the probe out of touch with the water,the controller shutdown the pump,the pump stop to drainage E point is the top water level control point,when the water level reached E point,the water touch the water,the controller open the pump,the pump begain to drainage. Water shortage protecter probe installation intruduction A,B do not to connect C,D point is the lowest water level control point,when the water drop below this point,C or D point out of touch with the water ,the controller shutdown the pump. E should connect with C Up and down cistern combine control probe installation intrunduction A is the upper cistern(or water tower)'s top water level control point,when water reached A point,the probe touch with water,the controller shutdown the pump. B is the cistern(or water tower)'s lowest water level control point,when water drop below B point,the probe out of touch with water,the controller open the pump ,the upper cistern begain to store water. C is the upper and down cistern(or water tower)'s ground line,against the bottom upper and down cistern(or water tower). If do not need to drainage,E do not need to connect. D is the down cistern's lowest water level control point,when wate level drop below D point,the probe touch with water,the controller shutdown the pump the cistern stop to drainage. E is the down cistern's top control point,when water reached E point,the probe touch with water,the controller open the pump,the cistern begain to drainage.