Полный автоматическая настройка системы делать кирпича станки

1.Product description: the system consists of 6 sets of equipment of lengthened automatic stripe cutting machine, ZQP36 automatic blank cutting machine, GD automatic transition machine, MPJ automatic, FPJ blank separating machine andautomaticturning vehicle of drying car. 2.Technical Parameters: Automatic Stripe Cutting and Blank Cutting System Installed capacitylength of maximum blank cutting mudProduction capacityMaximum pressure of hydraulic systemgas source pressuremaximum pushing timesNature of the mudoutline dimension(mm)2.2kw+(Unified equipment of motor in hydraulic station, 15kw in total)2000mm25000 pieces/hr (standard)10Mpa0.6MP≤14times/minSemi-hard plastic, hard plastic3646x1455x1415 (Blank ) 3264x995x755(Stripe cutting machine)Grouping Machine Waiting for Transition Installed capacityLength of maximum blank cutting mudProduction capacitysystemMaximum pushing timesoutline dimension(mm)2.2KW+ (unified equipment of motor in hydraulic station,15kw in total1980mm25000pieces/hr3Mpa≤4times/min4400x1640x1599Automatic Separating Machine maximum blank separating piecesMaximum blank separating timesmax pressure of pushing gas sourceoutline dimension(mm)36 pieces(standard)4 times/min0.6Mpa3500x1000x690Automatic Setting Machine Installed capacityProduction capacityMaximum oil pressure required by ascending and descendingmaximun pressure of folder blank gas sourceoutline dimension(mm)3kw+(unified equipment of motor in hydraulic station,15kw in total)≤120vehicles/hr10Mpa0.6Mpa4750x4000x2926+900Automatic Turning Vehicle of Drying Car installed capacityProduction capacityMaximum turning timesThe maximum oil voltage required by turningoutline dimension(mm)Unified equipment of motor in hydraulic station, 15kw in total≤120 vehicles/hr4 timese/min6Mpa5689x1275x5083.Advantages: a, high yield; the maximum f the system exceeds 20,000 standard s / hour, while the maximum yield of domestic similar products is below 15,000 standard pieces / hour; b, and small mud; the system takes the approach of soft start and soft stop with electrode, thus having low impact on mud and accurate positioning. The domestic similar products mostly adopt baffle positioning methods, which have strong impact on mud, thus the front mud is severely distorted because of impact; c, transition is added to avoid shutdown when the mud is too quick; d, is taken to avoid drooping blank and damage of plate to the surface of blank; e, by turning of drying car not only saves time but also adds stability during the operation of setting machines; f, energy- saving, small power, steady work; the automatic setting hydraulic system adopts the operating mode of energy storage container and single drive to avoid frequent start of motor.