Плитка Клей Бетон Добавка

Tile Adhesive Concrete Admixture Operative Norm JC/T547-2005<ceramics tile adhesive > Characteristics Adjust time(min) ≥5 Lay time(min) ≥10 Air dry time About 2h Performance 1. The product is a new modified polymer tile adhesive, no poison and protect the environment. 2. Excellent ability of anti-sagging, and easy to operate. 3. High cohesive force on the wall and the tile, air-tightness and waterproofing. 4. Apply directly on the thin bed, easy to operate and save time. Scope of Using The tile adhesive used for adhering various types of tiles, marble, granite, stones and etc. refer the chart: Type Scope of Using1Used for sticking on cement fundus of internal & external wall, washroom, kitchen and Min, Mid pottery face brick. 2Used for sticking larger or Min & Mid marble, granite, internal & external wall, floor and old facing retread. 3Used for sticking large marble, granite, internal & external wall, floor and old facing retread. Our company supplies the masterbatch of various pattern. We would supply the specific description according the situation of client. Use Method 1. Mix ratio: powder :water =3:1 2. Pour the powder into water, stirring the mixture with the electric mixer until it is equal, no block and creamy, then allow the mixture stand of 2-3min, better to stir it again. 3. Apply the mortar on the required substrate with trowel, plaster 1 m² per time, and then squeeze the tiles on it. 4. If the back joint is deep, it is better to apply both the front and behind surfaces to ensure the strong adhesion. Package and Storage 25kg/pack , store at the dry and ventilation places, the shelf life is 6 months. Attentions 1. Better to use at the temperature 5ºC - 40ºC, not to mix the dry block mortar with water. 2. Ensure the vertical and evenness of the base substrate, grouting or enter should be started only after at least 24hours after the tiles are fixed. 3. If the temperature of the substrate is high (40 ºC), water the substrate to keep wet to prevent the mortar losing water fast. 4. Choose the proper grouting agent for the gap between the blocks. 5. Clean all the surface of tiles lightly using a wet sponge or cloth before adhesive cures. 6 Clean the substrate and tiles, remove the dust ,oil point and other dirty points, the loose part of the old surface must be leveled.