пластиковые инъекции плесень Кубок

plastic injection cup mould -Product Material:Polycarbonate -Impression Surface Material:20 – 28-32 Rc (German 718) -Finish (12.10):A-2 #6 diamond buff -Gate Location(s):Center of Cavity,Cavity bottom insert to have dedicated cooling line around the valve gate.Cavity bottom will have (2) die springs per lifter to assist with breakaway during mold opening. -Gate Size:TBD -Locating Ring (16.51):4”/5” flip flop design -Each lifter will be timed with (2) Thompson rods with bronze bushings. Rods to be 2” diameter. -Lifters will have water for cooling. -Polish cavity after plating to remove all high spots. -Drilling Size:9/16” Dia. -Each mold plate will have a lifting hole on each side of the plate. -Each Clamp plate will have (4) lifting holes on the platen surface of the plate. -All air poppet valves and pressed in pins will have access holes drilled through -mold and clamp plates to allow removal without disassembling mold.