Patternless обрезки объектива AL-1000 Новая модель

Processing system Beveling Auto: Computer-calculated bevel Guided: Manual bevel setting, which enables you to select either the curve profiling the front surface, the curve profiling the rear surface, the specified curve value, the position ratio or tilting amount EX Flat(Rimless)edging Flat edging EX Grooving Auto: Computer-calculated groove position and curve EX Polishing Chamfering Processing lens Glass, plastic, high index plastic, polycarbonate, acrylic resin, trivex (except for glass with Type PLB) Processing range Max.Lens size: 90mm or less in diameter Layout range: 110mm or less in diameter Min. (without safety level) In flat edging:28mm or more in diameter (when replaced with the lens adapter and lens calmp for half-eye lens, up to min. 21mm dia., vertical width:19mm)(when the optional pliable cup is used, up to min.32mm dia., vertical width:19mm) In beveling: 30mm or more in diameter (when replaced with the lens adapter and lens clamp for half-eye lens, up to min. 22mm dia., vertical width:20mm)(when the iptional pliable cup is used, up to min.33mmdia.,vertical width:20mm) Min.(with safety bevel) In flat edging: 34mm or more in diameter (when replaced with the lens adapter and lens clamp for half-eye lens, up to min.28mmdia., vertical width: 25mm)(when the optional pliable cup is used, up to min.32mm dia., vertical width: 25mm) In beveling: 36mm or more in dianmeter (when replaced with the lens adapter and lens clamp for half-eye lens, up to min. 29mm dia., vertical width: 26mm)(when the optional pliable cup is used, up to min.34mm dia., vertical width: 26mm) *The processing range may change according to the processing mode.