OT Series selfpriming канализационные насосы

OT series selfpriming sewage pumps Design: Upon starting the pump, pressure drop occurs at the eye of the impeller which will give rise to pressure differences within the pump system (pump casing & suction pipe) and outside the pump system. As the pressure continues to drop in the pump system, a mixture of liquid and air will start to flow into the pump due to higher atmospheric pressure outside the pump system.The mixture of liquid and air will flow through the casing chamber designed like a diffuser through the inletand then to the discharge port. At the discharge port, air being lighter will be extricated through the discharge piping. The liquid being heavier will fall back into the pump chamber and re-mix with the inlet liquid. This process is repeated till air in the suction pipe and pump casing is fully emptied and filled with liquid. At this point, the pump will then be fully primed and achieve the self-priming effect.OT series selfpriming sewage pumpsPumped Liquid: Different Clean and dirty liquids of neutral or Alkali at viscosity up to 50mm2/s (cSt).OT series selfpriming sewage pumpsShaft Seal:Mechanical Seal---Sic-Sic/Vinton.OT series selfpriming sewage pumpsFlange Attached: Screw Flange for size up to 4 inchNonStandard Flange for size more than 4 inchOT series selfpriming sewage pumpsTechnical Data: Application: 1. IndustryFlow: 4-480m3/h 2. Civil EnginneringHead:4-400m 3. Marine DutySpeed: 1450rpm/2900rpm(50Hz) 4. Sewage 1750rpm/3500rpm(60Hz) 5. Water TreatmentTemperature: -10°C---80°C 6. Agriculture.Operating Pressure: 6Bar.OT series selfpriming sewage pumps