Ортопедические повязки

Kangda Brand orthopedic casting tapewhich isone new medical bandage substitutes of the plaster bandage /P.O.P bandage is used for orthopedic shaping /moulding, which consists of a knitted fiberglass fabric and water-activated polyurethane resin. Characteristics It is one new subtitute of the traditional plaster bandageCharacter of new medical bangdage(orthopedic casting tape )Be used in orthopedic molding and fixing 1 Molding fast It begin to mold after opening the package and inmmersing into the water,20 mins later, it can bear weight , but the plaste bandage need more hours for the complete molding.2 High hardness and light weight More than 20 times harder, 5 times lighter and use less than the traditional plaster bandage3 Good air pemeability Unique kintted net stucture make the bandage many holes in the surface to keep good air ventilation and prevent skin damp,hot&pruritus.4 Excellent X-ray radiolucence Excellent X-ray radiolucence make it convenient to take X-ray photos and to check the bone healing without removing the bandage ,or the plaster need do remove it .5 Water-proof The mositure absorbed percent is 85% less than plaster bandage ,even on the situation of the patient touching the water,it still can keep dry in the injured part.6 Environment friendly Material are environmental friendly ,which can not produce polluted gas after being burn down.7 Simple operatinon Can be done under the room remperature and use the room temperature water and doctor can complete the operation in short time. 8 Can be used in first -aidSpecification and Size 2in KD002 5.0 cm×360cm 10Rolls/Box 3in KD003 7.5 cm×360cm 10Rolls/Box 4in KD004 10.0cm×360cm 10Rolls/Box 5in KD005 12.5cm×360cm 10Rolls/Box 6in KD006 15.0cm×360cm 10Rolls/Box Operation 1. Put on the padded covering in the affected body part, and twine with the cotton paper. 2. Wear surgical gloves. 3. Before opening the package, choose the roll of proper size. 4. Immerse the roll in room temperature water for 2-3 secondsand squeeze it 2-3 times. 5. Wrap spirally, overlapping the previous layerby one-half or two-thirds the width of the roll. Just 3-4 layers provide a strong non-weight-bearing cast and 5-6 layers are typically adequate for weight-bearing cast. 6. KangdaCast is sufficiently cured to pervert further moldingin 3-5 minutes after immersion in the water. Allow about 10 minutes for sufficient cureand let patients do not move during this time. 7. KangdaCast may be windowed, trimmed or removed with traditional cast saw equipment. Precaution Please apply the surgical rubber gloveswhen you operate the product. When the resin is stuck to operator, please wipe it out with cotton swab with acetone. Recommended Amount of Usage Size Use 2in Childrens hands, fingers, and toes 3in Childrens wrists, ankles, and arms and legs 4in Childrens legs and ankles, adults hands and wrists 5in Adults arms and legs 6in Adults arms and legsStorage Be careful not to break the package. Store KANGDA Cast at room temperature. Damaged products by careless handing cannot be replaced.Please handle and store them carefully.The shelf life of KANGDA Cast is 3 years from the day of production.