Неметаллические косвенным индукционного нагрева питания Inve

Non-metallic indirect Induction Heating Power Supply Atec series of induction heating power supply for non-metallic indirect heating: Atec series of induction heating power supply through conductive materials, such as the crucible, container, and channels to indirect heat various non-conductive non-metallic material, according to different materials and different sizes, make a specific impedance matching to achieve good heating effect. All air cooled structures, systems with high efficiency. IGBT inverter, the efficiency and power factor are high. Rated Power continuous operation design, system failure rate is low, the device has no water system failure. Power factor high, above 50% load, input power factor above 0.90.Built-in temperature PID procedures, can realize constant temperature heating.A variety of control methods and a rich interface, easy to implement automatic control. Precise control of the DSP, the frequency of automatic tracking, ensure that devices work in the best resonant state; and if the grid voltage fluctuated, the output power will remain unchanged. Fully functional and reliable protection limit, short circuit in the sensor, workpiece short-circuit, overload operation, abnormal fluctuations of the grid, the equipment will not be damaged. Output transformer isolation, the sensor voltage is low, and can be single-grounded. Air-cooled transformer design life of 10 years, no brass jams. No polarity filter capacitor design life of 10 years (electrolytic capacitors less than 5 years). The parameter setting functions online.