Нефтеперерабатывающая в концентрации бумажной машин

Advantages: 1.Suitable for handling all types of pulp species, various types of straw pulp, waste paper pulp, fiber itself is low intensity, short fibers in the beating process should try to avoid being cut off, which is lower in the plasma concentration of beating the advantage of beating; wide leaf pulp, fiber short and hard, to use its full points while minimizing the wire cut off the broom, which is a low pulp beating can not solve the problem, and the use of strong beating, is easy. 2. A large number of manufacturers using the technology in the beating strong results show that the index into the physical strength of paper can increase 20-30%. 3. Significant decline in energy consumption, beating, beating Section in the entire papermaking process Sec of large energy consumption, energy consumption generally accounts for 30-50% of tons of paper, the strong beating technology, due to lower concentration levels Beating Beating concentration increased significantly, resulting in improved pulp per unit time over the amount of energy beating down 30-50% generally Beating the principle of concentrated mill: Process is by beating the pulp fibers for the relative motion of two mechanical components (such as disk grinding mill two) small gap, the mechanical components of the surface ridges on the direct effect of fiber, and the friction between the role of fiber with the result that fibers break down, break to pieces of paper and pulp group of single fiber cross-sectional, longitudinal, in silk, broom until the process of fine fibrosis. In this process, the role is to take place simultaneously. However, due to beating equipment and process is different than the role of size, strength is different, the effect of beating is not the same. Structure Mainly by strong refiner in the feeding system, refining system, the electrical transmission system composed of feeding system by the speed reducer, feed screw and other components. Refining system mainly by grinding chamber, rotor, stator and electric (manual) adjustment of the gap adjusting device and so on.