на водной основе эпоксидной краски Грунтовка

D-77 Teligu water-based Epoxy Primer paintProperties 1. use water as the diluent, non-toxic, environmental protection material, avoiding the risk of fire. 2. Enhance the adhesion between the base and the painting layer3. suitable for the wet surface4. with a one-way ventilation5. Lower cost than the solvent-based material6.with no bad solvent smell during the construction process.7. With water permeability, it can well protect the floor from being damaged by the water pressure.ApplicationWidely used in damp ground, high-level working areas, basement wall and floor, office floor, house decoration, and some places have a high demand of environmental protection. Places have a high demand of dust-free, clean, and anti-abrasion, well decoration effect, such as food factory, industrial workshop, electric factory Suitable for the non-ventilated enclosed places.Technical parameters ItemText Standard and DescriptionIndexMaterialEpoxy and curing agentColorLight brownTouch Dry (h)25°C4Hard Dry (h)25°C24Adhesion GradeGB/T9286-1998≤0Solid contentGB/6751-8645%Pencil hardGBT/6739-1996≥2Impact resistance (kg·cm)GB/T1732-9350FlexibilityGB6742-861Material Consumption 0.08 kg/m2Package Teligu Water-based Seal Premier D30Part A 5kg (Main agent, transparent)Part B 20kg (curing agent, light liqud)Batching ratio(weight ratio)A:B=1:4Construction designStir the Part A and Part B fully in 3-5 minutes.Because of the large difference in the viscosity of the two materials, we suggest that stir the equivalent Main agent and curing agent firstly, then add the left curing agent. Rolling coating once for general coating.After Hard Dry, continue the next step coating Cautions 1. It is water-based epoxy premier. Brush on the plain clean surface, dry or wet surface, but without water on the surface.2. The ambient temperature is above 15°C, relative Humidity under 90%. The relative humidity affect the gloss, the lower humidity the higher gloss.3. The epoxy resin Part A and Part B must be strictly mixed under the guiding proportion. After fully stirred, it can be roller painting4. Please increase the coating times when the surface is too bad.5. It’s better to used up in 30min after mixed. In case of waste the batching quantity accords with the consumption.6. Gelled paint can not be used.7. Construction by the professionals