MEAN WELL 30W один выход индикатор питания / индикатор D

MODEL PLN-30-24OUTPUTDCVOLTAGE 24V CONSTANT CURRENT REGION Note.6 16.8 24V RATEDCURRENT 1.25A CURRENTRANGE 0 1.25A RATEDPOWER 30W RIPPLE&NOISENOTE.2 2.6VP-P VOLTAGE ADJ RANGE ±10%. Can be adjusted by internal potential meter SVR1 CURRENT ADJ. RANGE Note.5 3% -25%. Can be adjusted by internal potential meter SVR2 VOLTAGETOLERANCENOTE.3 ±10% LINEREGULATION ±3.0% LOADREGULATION ±10% SETUP.RISEHOLD.TIME 1500ms, 150ms / 230VAC 3000ms, 150ms / 115VAC at full load INPUTVOLTAGERANGE 90 264VAC 127 370VDC FREQUENCYRANGE 47 63HZ EFFICIENCY 85% VOLTAGE RANGE PF>0.9/230VAC PF>0.95/115VAC at full load AC CURRENT 0.4A/115VAC 0.2A/230VAC INRUSH CURRENT 40A/230VAC LEAKAGECURRENT 0.5mA/240VAC PROTECTIONOVER CURRENT 110 120% Protection typeConstant current limiting,recovers automatically after fault condition is removed SHORT CIRCUIT Hiccup mode, recovers automatically after fault condition is removed. OVER VOLTAGE 27 34V Protection typeShut down o/p voltage,re-power on to recover. OVER TEMPERATURE 90± 10 (TSW1) Protection type : Shut down o/p voltage, re-power on to recover ENVIRONMENTWORKINGTIMP -30 +50(refer to output load derating curve) WORKINGHUMIDITY -20 90%Rhnon-condensing STORAGE TEMP HUMIDITY -40 +80 10 95%RH TEMPCOEFFICIENT ±0.06%(0 50) VIBRATION 10 500HZ,2G10min/1cycle period for 60 min each alongX,Y,Zaxes SAFETY&EMCSAFETYSTANDARDS TUV EN61347-1, EN61347-2-13, CAN/CSA C22.2 No. 223-M91(except for 48V), IP64 approved WITHSTAND VOLTAGE 1/P-0/P:3KVAC ISOLATIONRESISTANCE 1/P-0/P:>100M Ohms/500VDC/25/70%RH EMI CONDUCTICN& RADIATION Compliance to EN55015 HARMONICCURRENT Compliance to EN61000-3-2 Class C (>80% load), Class D (>50% load) ; EN61000-3-3 EMS IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, EN61547, light industry level, criteria A QTHERSMTBF 621.4Khrs min MIL-HDBK-217F(25) DIMENSION 145*47*30mm(L*W*H) PACKING 0.22Kg; 60pcs/14.2Kg/1.25CUFT NOTE1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.3. Tolerance : includes set up tolerance, line regulation and load regulation.4. Please refer to OLP characteristics.5. Output voltage can be adjusted through the SVR1 on the PCB; limit of output constant current level can be adjusted through the SVR2 on the PCB.6. Constant current operation region is within 70% 100% rated output voltage. This is the suitable operation region for LED related applications, but please reconfirm special electrical requirements for some specific system design.