Gr5 титановую пластину для промышленности

titaniumplate (5.0-8.0)×≤2500W×≤4000L Definitions of Terms Specific to This Standard: Any product over 0.187 in. (4.75 mm) in thickness and over 10 in. (254 mm) in width is classified as plate. Designation: B 265 This specification covers annealed titanium and titanium alloyplate. Grade 5—Titanium alloy (6 % aluminum, 4 % vanadium) DesignationChemical Composition (wt %)TiAlVFeCNH0Other residualssingleallGrade 5balance5.5-6.753.5-4.50.400.080.050.0150.200.100.40 Ordering Information Orders for materials under this specification shall include the following information as applicable: 1 Grade number 2 Product limitations 3 Special mechanical properties 4 Marking 5 Finish 6 Packaging 7 Required reports 8 Disposition of rejected material Sampling for Chemical Analysis Samples for chemical analysis shall be representative of the material being tested. The utmost care must be used in sampling titanium for chemical analysis because of its great affinity for elements such as oxygen, nitrogen, and hydrogen. Therefore, in cutting samples for analysis, the operation should be carried out insofar as possible in a dust-free atmosphere. Chips should be collected from clean metal and tools should be clean and sharp. Samples for analysis should be stored in suitable containers. Certification If so requested by the purchaser, we will supply at least one copy of his report certifying that the material supplied has been inspected and tested in accordance with the requirements of this specification and that the results of chemical analysis and mechanical tests meet the requirements of this specification for the appropriate grade.