горячего расплава маркировки машины

Hot melt labeling machine Equipment brief introduction 1.1).easy operation to adjust label cutting knife1.2).vacuum drum made of high rigid material to reduce friction and static1.3)rapid changeovers: modular design and quick release change parts have changeovers fast and easy in ten minutes1.4).using handle to adjust the position of cutting knife is possible and exactly1.5).vacuum manifold at the lower part of drum and cutter, made of heat & wear resistant material1.6).automatic label length controller to adjust position of I-MARK2.label material: OPP, PVC, PAPER et c. label size:as demandedlabeling method: line type3. machine description3.1) roll-fed type3.2) label in-fed from label station is conveyed to label in-feed roll-er through label guide roller3.3) sensors will check I-MARK of label automatically when label reaches label in-feed roller3.4) as soon as the position of I-MARK is confirmed, Encoder will adjust the operation speed of label in-feed roller and then appoint the label cutting position3.5) label which has been cut is conveyed to vacuum drum3.6) after checking label attached on vacuum drum by sensor, label is conveyed to glue roller and theninject hot melt on label3.7) to adjust containers by in-feed star wheel and do labeling in roller zone for the first time and thenlabeling operation will be done perfectly by side belt.4. safety4.1)control : PMC, inverter4.2) safety attachmentsoverload running safety equipment attached on driving zonestopper for abnormity operation of in-feed star wheelno bottle fed (sensor check)overload for bottle fed (sensor check)no bottle no labeling