Этикетка машины

Label Machine overview This machine is designed to be taken in the first sector of the labeling change on a post by another round of rubber get a little sticky glue and then to label the gear stick Department get a label to the vacuum suction round of the position paper, marked off by efforts from Under the label. At the same time, the label switching to the vacuum-belt paper, the use of vacuum suction, so that the labels attached to the belt-paper on the labeling into the area, so that the labels attached by the chain of transmission in the bottle. This cycle of action, the completion of local production. In order to make the products attractive, as well as the normal operation of machinery, the operator should also pay attention to the following matters.1, the glue of choice - which is commonly used white plastic Xiongmao Pai (polyvinyl acetate emulsion fat) to add in glue, it must be careful not too much to maintain as long as there are rounds of rubber layer film can be. This is because too much glue to make it in the label attached, as a result of the bottle and squeezed the sponge board will be too much of the glue left on the belt-and sponge pad of paper, and prevent future tags attached.2, dealing with labels - in order to make the labels attached to the full in the bottle, and the appearance of the product, the label should be formed in order to fully on plastic. As the room temperature, labeling in the air easily have a damp curly phenomenon. Therefore, to preserve the label must be used before and after the rigid fixation of the plate, and then clamping rubber band.3, the handling of the bottle - the bottle labels attached, the outer surface of the oil or dust may not have a criminal record. The mechanism is a kind of new-type & advanced driving device of hot shrink label sleeving machine, that is a kind of device with four-wheel drive, automatic centering and four-wheel balanced pressure, which has achieved the goals of smooth, stable and swift label transmission Speed(b/min) 250-300 Dimensions L*W*H(mm) 2100*850*2000 Diameter Of The Bottle(mm) φ28-φ125 Length Of The Label (mm) 30-250 Thickness Of The Label(mm) 0.035-0.13