Два Часть РТВ силиконовая для Статуи литейного

[1]Specifications of Two Part RTV SiliconeSilicone rubber for molding: 1 )Low shrinkage,2 )Good operation3)High tear and tensile strength,4) Easy demould.5) Condensation cured silicone rubber6)Hardness can be adjusted according to the requirements of curstomer from 15-30 shore A.7) Any color of silicone is no problem[2]Mold making silicone rubber is used for - Unsaturated polyester resins, epoxy resins, polyurethane resins.- Polyurethane elastomers.- Natural and synthetic waxes, candle, soap.- Plasters, gypsum, column, cornices, domes, cements, concrete .- Low-melting point- Imitation wood and bench.[3]Data of Two Part RTV SiliconeModel Color Viscosity Hardness (Mpa) Tensile Strength(Mpa) Tear Strength(KN/m) Elongation (%) Mixing ratio (%) Pot life (Min) Demould time (H)M-20Pwhite10000-1300020±2≥2.8≥2.0≥4002 510-302 7M-25Pwhite17000-1900025±2≥3.0≥2.5≥4002 510-302 7M-30Pwhite24000-2900030±2≥3.6≥2.7≥4202 510-302 7[4]The differences of M-20P,M-2P5,M-30P A.M-20P is mainly used for molds with small, delicated patterns. Pouring method is the best way because of good fluidity. The hardness is 20 shore A.B.M-25P is for medium size molds making. It’s also used for pouring methods. The hardness is 25 shore A.C.M-30P is applicable for large mold making since hard hardness. Both pouring and brushing method are ok. The hardness is 30 shore A.Any further information required ,pls feel free to contact Miss Sherry.TEL: +86-755-27125425Mobile: +86-15014058045Welcome to visit www(dot)china-silicon(dot)net and call for any time.