2011 год новый льдогенератор SD-90 SD-120

CE approval, Model: SD-90 Daily Production :90KG/198Lg Bin Capacity :45KG/99LB Dimension :830*608*1010MM Voltage:220V Power:0.65kW model:SD-120 Daily Production:120kg/264lb Bin Capacity:45KG/99LB Dimensions without packing:830*608*1010MM Voltage:220v Power:0.7kw 3. Installation: (1) The location for the machine should be equipped with the following devices: a. power of 220V/50Hz b. water resource and switch c. pipeline for water drainage (2) The machine should be put in level to keep the ice producing effort and prevent from the vibration. (3) The machine has to be put in the good ventilation location, it should kept away 150mm from the other objects for the air exchange. The machine should be kept away from other heating resources, such as heaters and ovens etc. The machine should be equipped with suitable power switch, fuse and breaker (model: DZ12L-60G/1N, the rated breaking current is 15mA, the non- breaking current is 7.5mA). The current volume for the socket and cable is not less than 10A. The socket must have qualified earthling wire. (4) If the water quality is not so good, you should connect a filter to the tap. The water quality for the ice producing should meet the drinking standards. Transportation and storage In transportation, it should be very careful, prevention from heavy vibration. The machine in package cannot be put in open-air for long time. It should be put in the good facility of air and non-corrosive air storage. It cannot be put upside-down. If it is necessary to put it in open-air, it should have waterproof facilities. Operation The appliance is equipped with temperature and time control system. The process is completed automatically from water in to ice out. It is no need man power, so it is simple and convenient in operation. What you have to do is only turning on the power and water. During the operation, when the cabinet is full of ice cubes, the machine will stop automatically. You should take out some of ice cubes and the machine will start again. You should connect water pipe for the machine. The water pressure should be between 0.1-0.5MPa. The flow can be adjusted by the tap and it depends on the drainage volume of frost-melting. If the drainage is big, turn up the tap, if the drainage is small, turn down the tap. The silicon balls inside the machine are for prevention of the internal bottom from striking of the ice falling down. So, the silicon balls have to be put in the operation and taken out for cleaning regularly. note:the above information is for reference only,and al kind prevail! product specifications subject to change without notice.