Meanwell USP-225-24 Schaltnetzteil / SMPS / PS

Meanwell USP-225-24 Switching power supply Universal AC input / Full range High power density 4.7w/in3 MODEL SP-225-24OUTPUTDCVOLTAGE 24V RATEDCURRENT 9.4A CURRENTRANGE 0 9.4A RATEDPOWER 225.6W RIPPLE & NOISE (max.) Note.2 150MVP-P VOLTAGEADJ.RANGE 21.6 26.4V VOLTAGE TOLERANCE Note.3 ±2.0% LINEREGULATION ±0.5% LOADREGULATION ±1.0% SETUP,RISE TIME 500ms, 30ms/VAC 1200,30ms/115VAC at full load HOLD,TIME(TYP.) 22ms/230VAC 22ms/115VAC at full load INPUTVOLTAGERANGE 90 264VAC 127 370VDC FREQUENCYRANGE 47 63HZ POWER FACTOR (Typ.) PF>0.93/230VAC PF>0.97/115VAC at full load EFFICIENCY (Typ.) 85% 115VAC 3.3A AC CURRENT (Typ.) 230VAC 1.6A INRUSH CURRENT (Typ.) 15A/115VAC 30A/230VAC LEAKAGECURRENT <3.5mA/240VAC PROTECTIONOVERLOAD 105 150%rated output power Protection type : Constant current limiting, recovers automatically after fault condition is removed OVER VOLTAGE 26.4 32.4V Protection type : Shut down o/p voltage, re-power on to recover OVER TEMPERATURE 95 ±5 (TSW1 : detect on heatsink of power transistor) Protection type : Shut down o/p voltage, recovers automatically after temperature goes down FUNCTIONREMOTE CONTROL(OPTION) CN1:4 10VDC POWER ON, <0 0.8VDC POWER OFF ENVIRONMENTWORKING TEMP. -10 +60 (refer to output load derating curve) WORKING HUMIDITY 20 90% RH non-condensing STORAGE TEMP HUMIDITY -20 +85 10 95%RH TEMPCOEFFICIENT 0.05%(0 50) VIBRATION 10 500HZ,2G10min/1cycle,60min.each alongX,Y,Zaxes SAFETY&EMCSAFETY STANDARDS UL60950-1, TUV EN60950-1 APPROVED WITHSTAND VOLTAGE 1/P-0/P:3KVAC 1/P-FG:1.5KVAC 0/P-FG:0.5KVAC ISOLATIONRESISTANCE 1/P-0/P,1/P-FG,0/P-FG:100M Ohms/500VDC EMI CONDUCTICN& RADIATION Compliance to EN55022(CISPR22)classB HARMONICCURRENT Compliance to EN61000-3-2,-3 EMS IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11 ENV50204,EN55024, Light industry level criteriaA QTHERSMTBF 183.8Khrs min MIL-HDBK-217F(25) DIMENSION 199*99*50mm(L*W*H) PACKING 0.85Kg 20pcs / 17.9Kg / 1.28CUFT NOTE1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.3. Tolerance : includes set up tolerance, line regulation and load regulation.4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meetsEMC directives.