Blau tack PT-75

power tack Permanently plastic, reusable multi purpose adhesive. Excellent adhesive qualities. Very piable. Non toxic - safe for all the family. Designed to hang posters, hold many ordinary house hold objects in place, temporarily stop leaks around the house. Has a multitude of uses in the home, office, school, factory/workshop, etc.The original re-useable adhesiveCan you use it to stick up things or hold thingsStick to any clean, dry surfaceNever dies out100% Re-usableLeaves no residueNon-toxicUse in stead of sticky tape, tacks, staples, pins, wax, paste, magnet, glue, caulking in hundreds of usesHOW TO USE POWER TACKPower tack will stick anything to anything as long as the surface are clean and dry. P-T will not leave holes or messy residues , as will tacks or stick tape .P-T will not harden, and can be used over and over. P-T is not affected by normal temperature variations, or is it soluble in water , or in any way affected by moisture. P-T contains no silicones and is non-toxic. You will find many applications where P-T will work better than other adhesives or fastening devices .HDIRECTIONS1. To activate power tack , pull it like taffy until it is warm.2. Pull off a suitable piece and gently roll it into a ball .3. Place the ball of power tack between the surfaces you want to fasten and P-R-E-S-S HARD.4. To remove power tack, gently pull it away, or roll it off with the forefinger and save for re-use.For perfect results , do not deviate form the above procedure , and repeat this process every time P-T is used .and remember , DO NOT SKIMP! Always use more than enough P-T to do the job because P-T is 100% re-usable . It won`t cost you any more to do the job right.NOTICEPower tack is not intended to replace nails or hooks or other devices or adhesives used to hang or attach large or heavy objects.P-T should not be used where paint and wallpaper are not tight on the wall .P-T should always not be used on fresh paint or on soft wallpaper. P-T should always be remove from paper by rolling it off with the forefinger. On some types of paint and wallpaper , P-T might leave a spot .Normally , such spots can be easily removed by using lighter fluid , or a household solvent such as tri-chloroethane. However , before using on wallpaper flat paint, we suggest placing a small piece of P-T on a inconspicuous spot for a period of about one week .If a mark does not appear by the end of this time , normally P-T can be used safely .If particles of P-T should remain embedded in concrete , cinder block, brick , etc., remove by dabbing the area with a larger piece of well activated P-T , or use lighter fluid or solvent.