2011 Jahre neue Elektro-Vertikal Rotisseries

Specifications:ModelYXD-206-2NameThe Electric RotisserieVoltage3N 380VOutput14.52kWOil Dosage50HzTemperature50 300°CSize1340×550×1600(mm)Transportation and storage:When being transported, be careful not to shake the machine violently or crash it with anything else; don’t put it outdoors or in the direct sunlight. If so, avoid rainfall; Store it in ventilated places out of erosive gases; Don’t put it up-side-down. Cautions:1.Install the machine in the stable place; keep a distance of 10cm from the flammable to the left; keep its back away from the wall for 30cm. 2.There is a hole for spreading heat,where nothing can be put.If the machine will be used for a long time,unload the upper board,which will make it easier to spread heat and is better for the motor. 3.The pressure should be the same as the one on the nameplate of the machine(about 220V±10%). 4.Use a suitable switch,fusion and protect mode near the machine.Don’t store too much rubbish around to make it easy to operate. 5.The connective port is at the back of the machine,connect it with copper wires of not less than 2.5mm2 of safe ground wires. 6.The ground wires of the machine (the yellow one and the green one )come out from the same place as the power,connect them with safe ground wires. 7.If the power wires should be changed,change them with YCW yellow and green copper cables of 8 10A/mm2,which is oil-proof. 8.Make sure the wires contact well and firmly,the output is suitable and the ground wires are safe before using. 9.All the connection and installation should be done by qualified electricians. 10.This equipment is not equipped to be used by unwell, unresponsive or mentally disturbed people, including children, unless under the guidance or help of persons who are responsible for their security.Keep an eye on children and keep them away from playing aroundthe equipment. Warning:This equipment must be earthed. And the earth wire is strictly forbid to connect pipes such as water pipe, gas pipe, warm air pipe and so on, otherwise serious consequence may occur. Specifications. ModelVoltagePowerFrequencyTemperatureUnit sizeYXD-207-2220V1100W50Hz50 3001340×550×1600Gas:LPG with low-pressure regulator. It is forbidden to us middle and high-pressure regulator. Gas consumption:0.3Kg/time Notice:(1) There are 12 hooks for the roaster to fix the food. (2) When you turn the switch to the position “ON”, the roasting pole swings. When you turn the switch to the position of “OFF’ the roasting pole stop swing. (3) When you want to put in or put out of the roasted food, you can press the contacting swing button, the roasting pole can stop at any position. (4) The roaster should be put in the place with good ventilation to prevent from gas accidence. 3. Transportation and storage In transportation, it should be very careful, prevention from heavy vibration. The equipment in package cannot be put in open-air for long time. It should be put in the good facility of air and non-corrosive air storage. It cannot be put upside-down. If it is necessary to put it in open-air, it should have waterproof facilities 4. Notes and operation environment The roaster should be put in the stable location. It should have 10cm distances from the other objects. The backside should be 30cm away from the wall and the un- inflammables. In the operation, the protection measures should taken to prevent from hurt by the heat glass.If you find any gas leakage, shut off the gas valve, open windows. Never make any ignition and switch on or off the power. The voltage of the equipment is 220V The difference of voltage cannot bebeyond +10%. You should install power switch, fuse and breaker for the roaster. The objects cannot be put around the switch.The earthing wire (the yellow and green wire) leads out with the power wire. The plug should be plugged to the socket with earthing wire.Before operation, you should check the electronics and power and earthing. Qualified electrician should do the electricity connection and installation.In the left low side, there is a gas connector; you should use a LPG rubber hose to connect it with the low-pressure regulator of gas cylinder.This equipment is not equipped to be used by unwell, unresponsive or mentally disturbed people, including children, unless under the guidance or help of persons who are responsible for their security. Keep an eye on children and keep them away from playing around the equipment.WARNING: The distance between gas cylinder and roaster should be over 3 meters.